Manual Number: 00431-220-5
Page A-18
SB586T Series Manual
Chapter 6: Peripheral Setup
Choose the Peripheral Setup entry from the AMIBIOS HIFLEX Setup screen to display the Periph-
eral Setup options, described below.
Onboard FDC
This option specifies whether the onboard floppy disk controller is enabled. The settings are AUTO,
ENABLED, and DISABLED. The optimal and fail-safe default settings are
AUTO
.
Onboard Serial Port 1
Onboard Serial Port 2
These options specify the base I/O port address for the serial ports. The settings are 3E8h, 3F8h,
2E8H, 2F8H, AUTO, or DISABLED. The optimal and fail-safe default settings are
AUTO
.
Onboard Parallel Port
This option specifies the base I/O port address for the parallel port. The settings are 378H, 278H,
3BCH, AUTO, or DISABLED. The optimal and fail-safe settings are
AUTO.
Parallel Port Mode
This setting sets up the mode of the parallel port. The settings are NORMAL, EPP, or ECP.
The optimal and fail-safe default settings are
ECP
.
EPP Version
This setting sets the EPP standards when the Parallel Port Mode is set to EPP. The settings
are 1.7 or 1.9. The optimal and fail-safe default settings are
N/A.
Parallel Port IRQ
This setting allows selection of the IRQ to assist to the parallel port when applicable. The
settings are 5 or 7. The optimal and fail-safe default settings are
AUTO
.
Parallel Port DMA Channel
This setting allows selection of the DMA channel to assist to the parallel port when applicable.
The settings are 0, 1, 3, or 5. The optimal and fail-safe default settings are
AUTO
.
Onboard IDE
This option specifies the channel used by the IDE controller on the motherboard. The settings are
DISABLED, PRIMARY, SECONDARY, or BOTH
.
The optimal and fail-safe default settings are
BOTH.