Chapter 4: Maintenance and Troubleshooting
Manual Number: 00431-220-5
Page 4-1
Chapter 4: Maintenance and Troubleshooting
This chapter provides minimal maintenance and troubleshooting information for your SB586T single
board computer. If you would like assistance with these procedures, please call Technical Support at
800-480-0044
(U.S.) or
858-677-0877
(international).
Troubleshooting
All components of a computer are interrelated. That is, a video problem may be caused by the
disk controller. The simplest diagnostic technique involves replacing the suspect card with a new
one. If that doesnt fix the problem, remove all cards except for the minimum required by the
system. Then run the system, replacing each card until the problem occurs.
FCC Compliance Statement for FCC Class A Devices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and radiates radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. Opera-
tion of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his or her own expense.
Changes or modifications not expressly approved by the party responsible for compliance could
void the users authority to operate the equipment.
Note:
The assembler of a personal computer system may be required to test the system and/or
make necessary modifications if a system is found to cause harmful interference or to be
non-compliant with the appropriate standards for its intended use.