Manual Number: 00431-220-5
Page 4-2
SB586T Series Manual
How to Remain CE Compliant
The SB586T Series boards are designed to be CE compliant when used in CE compliant chassis.
Maintaining CE compliance also requires proper cable and cabling techniques. Although ICS Ad-
vent offers accessories, the customer must ensure that these products are installed with proper
shielding to maintain CE compliance. ICS Advent does not offer engineering services for designing
cabling systems. In addition, ICS Advent will not retest or recertify systems or components that
have been reconfigured by customers.
WARNING!
The following procedures involve working with high voltage. Contact with this
voltage may cause serious injury. Accidental shorting of the circuits can damage
the computer.
CAUTION!
The following procedures involve working with a device that is sensitive to static
electricity. Use proper precautions to protect against electrostatic discharge (ESD).
Only qualified personnel should attempt these procedures.
CPU does not boot, there is no beep, and no video.
A. Ensure that the CPU is fully seated in the CPU socket and is correctly oriented to pin 1.
B. With power off, clear CMOS by shorting across E1 as discussed at the end of Chapter 3, then
try booting your system again.
C. Contact Customer Service at
800-480-0044
(U.S. and Canada) or
858-677-0877
(interna-
tional) to receive the latest BIOS flash file. Refer to Appendix A for BIOS upgrade instructions.
When booting, system reports 'No SCSI Boot Device Found'.
A. This message appears if there is no bootable device on the SCSI bus. Disable the SCSI controller
in CMOS setup if no SCSI devices are being used.
B. If a SCSI hard drive is installed, make sure that all cables and power connectors are attached to
the SCSI peripherals.