Auto Sentry® Petro - Installation Guide
30
System Wiring
In-Bay Wiring Layouts
Figure 24 is an example of a possible Network Communication Layout for an In-Bay Car Wash. See
the ICS System Installation Drawings that were prepared for your specific car wash site and given
to you by your ICS salesperson or technician.
Network Communication Layout
The wiring schedule for the Power Layout is found on page 26.
Figure 24. Network Communication Layout
HIGH SPEED
DSL / CABLE
MODEM
ROUTER /
FIREWALL
HIGH SPEED
DSL / Cable Modem
Connection Point
POS
FUEL COMPUTER
FOR WASH CODES
RJ45 MALE FLAT
SATIN CABLE
(SUPPLIED BY SITE
OR FUEL VENDOR)
DB9 MALE TO RJ45 FEMALE
CONNECTOR KIT (SUPPLIED BY
SITE OR FUEL VENDOR.)
CAT 6 SHIELDED
NETWORK
SWITCH
CAT 6 SHIELDED
Position the router and
modem within 6' of the
network switch.
IMPORTANT
:
x
IF USING EMV, RUN AN ADDITIONAL CAT 6 CABLE FROM THE AUTO
SENTRY PETRO CARD READER TO THE NETWORK SWITCH.
x
ICS SELLS CAT 6 SHIELDED CABLE.
x
THE UPS BACKUP BATTERY IS PREINSTALLED INSIDE THE AUTO SENTRY
HEAD, NO EXTERNAL UPS IS NEEDED FOR THE AUTO SENTRY PETRO.
NETWORK
COMMUNICATION
LAYOUT
*** The wiring and terminations are the responsibility of the car
wash owners, electrician, and/or supplied contractor. Please have
an electrician and/or car wash owner supplied contractor
complete all of the sitee s wiring pulls and terminations prior to the
ICS technician coming on site. All permanent site wiring
connections must be performed by a licensed electrician that must
comply with all local and national recommended standards.***