© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
5
V = Volts
A = Amps
= Alternating Current
Hz = Hertz (frequency)
/min (rpm) = Revolutions Per Minute
gpm = Gallons Per Minute
psi = Pounds per Square Inch of Pressure
bar = Metric unit of pressure approximating one atmosphere
IP66 = Ingress Protection classification per Standard EN 60529
Symbols & Labels
SYMBOLS AND LABELS
THE FOLLOWING SYMBOLS MAY BE FOUND THROUGHOUT THIS MANUAL
AND/OR ON THE POWER CUTTER AND ARE DESIGNED TO MAKE
YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES.
8
DO NOT USE A LADDER
Never stand on a ladder when using
the power cutter.
KERF WIDTH
Do not insert tool into slot
narrower than chain.
SOUND POWER
Sound power level
is 108 dB(A).
SLIPPERY SURFACE
Unsure footing can lead to
accidents.
AVOID CONTACT WITH
MOVING PARTS
Contact with moving parts can
cause injury.
DO NOT USE IF POWER CORD
IS CRACKED OR FRAYED
Damaged cords can cause
electrocution.
CONNECT GROUNDED
OUTLETS ONLY
Provides protection against risk of
fire, electrical shock, and explosion.
MAINTAIN ADEQUATE
WATER SUPPLY
Ensure water delivery of
20psi (1.4 bar) at a minimum flow
rate of 2gpm (8lpm) to cool,
lubricate and keep chain clean.
CHAIN DIRECTION OF TRAVEL
Bar and chain are non-directional.
Bar p/n 513122
Chain p/n 584292
Additional compatible bar & chain
part numbers listed on page 37.