© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
35
Maintenance
Snap Ring
Drive Shaft
Drive Sprocket
DRIVE SPROCKET ASSEMBLY REMOVAL/INSTALLATION
•
Disconnect power cutter from the power source.
•
Remove the side cover, bar clamp plate, guidebar and diamond chain.
•
Remove spline adapter snap ring from shaft.
•
Remove sprocket snap ring from spline adapter.
•
Remove spline adapter & drive sprocket from shaft.
•
Slide new sprocket onto spline adapter.
•
Replace sprocket snap ring onto spline adapter.
•
Slide spline adapter and drive sprocket onto shaft (assure flanged side of
adapter is facing out)
•
Replace spline adapter snap ring onto shaft and assure complete engagement
in shaft groove
•
Installation of new drive sprocket is complete.
•
Reinstall guidebar, diamond chain, bar clamp plate and side cover.
•
Assure diamond chain and guidebar are in good, useable condition. Worn or
damaged guidebar and chain can damage the new drive sprocket.