© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
27
PRE-OPERATION SAFETY CHECKS
•
Test
GFCI/RCD before each use. See label on GFCI/RCD for test
procedure.
•
If GFCI/RCD trip occurs, stop using tool immediately, disconnect from power
source, evaluate and remedy power source. If integrity of power source is verified
and GFCI/RCD trips persist, contact an authorized ICS Service Center.
•
Assure proper chain tension: The chain should be easily pulled around the
guidebar by hand.
•
Assure all safety devices are properly mounted and functional and that all
controls are in proper working order.
•
Be sure there are no obstructions (plumbing, electrical conduit, air ducts, etc.)
and no unnecessary people present
•
Always wear protective clothing, including hard hat, eye protection, hearing
protection, non-slip safety boots, gloves. Avoid wearing loose fitting clothing.
Use proper respiratory protection for your application.
•
Adequate water supply and pressure
Minimum flow: 2 gpm (8 lpm)
|
Minimum water pressure: 20 psi (1.4 bar)
Operation
