ICS ELECTRONICS 9099, Instruction Manual

Page: 62 / 178

3-16
3
TAbLE 3-2 IEEE-488.2 COMMON COMMANDS (CONT'D)
COMMAND NAME DESCRIPTION
Reset
Save
Service
Request
Enable
Service Request
Enable Query
Read Status Byte
Device Trigger
Self-Test Query
Wait-to-continue
saved configuration, updates all output levels
and re-initializes the UART. It does not change
the network interface. Allow the 9099 300 ms
to complete the *RCL command.
Restores the 9099 to its power-up state except
that the state of the network interface, enable
and event registers are unchanged, disables the
trigger function and pulses the Reset output
signal. Allow the 9099 300 ms to complete the
*RST command.
Saves current 9099 configuration in the F
l
ash.
*SAV 0 saves the current setting as the new power
on setting. <value>=0
Sets the "Service Request Enable Register" to
<value>. The value of bit six is ignored because
it is not used by the Service Request Enable
Register. <value> is an integer between 0 and
255, whose binary equivalent corresponds to the
state (1 or 0) of bits in the register. If <value>
is not between 0 and 255, an Execution Error is
generated.
9099 returns the <value> of the "Service Request
Enable Register" (with bit six set to zero). <value>
is an integer whose binary equivalent corresponds
to the state (1 or 0) of bits in the register.
9099 returns the <value> of the "Status Byte" with
bit six as the "Master Summary" bit. <value> is
an integer whose binary equivalent corresponds
to the state (1 or 0) of bits in the register.
No operation in the 9099.
Queries the results of the last self test. A zero
response indicates no failures. Other responses
are not returned as the unit will be running in a
blink LED loop and will be unable to respond
to the query.
No operation in the 9099.
*RST
*SAV <value>
*SRE <value>
*SRE?
*STb?
*TRG
*TST?
*WAI
*RCL <value>
continued