IR-712A Universal IR Learning Remote Module (Ver. 1.3, Aug/23/2016) 33
4.3 Learn and Test IR Commands
Follow the steps below and Fig. 4-6 to learn and test IR commands:
(1) Determine the IR command for learning by selecting the items in the
“Device Name”
and
“Command Name” combo boxes.
(2) Click the
“Learn On” button to enable the IR learning mode on IR-712A. At the
same time, the TR/LN LED is turned on to show the IR learning state.
(3) Aim the IR emitter head of the device
’s remote control at the IR input of IR-712A.
The distance less than 3 cm between the remote control and the IR-712A would be
best. Then, press the button of the remote control which is to be learned in a short
time. If the learning for the IR command is finished, the TR/LN LED will be turned
off and the IR learning data will be sent back to the Utility.
(4) Select the IR output channel. For example in fig. 4-6, the IR output channel is 1.
(5) Aim the head of the IR emitter cable plugged in the IR output 1 at the
corresponding IR-controlled device. Click
“Run Command” button to emit the IR
command from the IR-712A. You can check if the learned IR command is OK by
investigate the action of the appliance. If not, please repeat step 2 and step 3
again.
(6) Click
“Save this Cmd” button to save this IR learning command to the current item
of the
“Command Name” combo box, e.g. the item is “Play” in figure 4-6.
Repeat the above steps to learn all the IR commands.
Figure 4-6
The steps to learn IR commands.
1
2
3
5
2
4
6
距離：
≤ 3 cm
IR Input
遙控器
