TPD/VPD Series - Getting Started v.1.0.5
Page 68
Copyright@ 2012 ICP DAS CO., LTD. All Rights Reserved. E-mail: [email protected]
e.
Set the Address to 1, the Baud rate to 19200, and click the “Settings” button, and then
the following message will be displayed. Click the “OK” button to continue.
f.
Switch the I-7055 to “Normal” mode and reset the module, then search for the
module again to confirm the configuration.
M-7055D:
The settings are similar to those of the I-7055D, but the “Protocol” option should be set
to “Modbus RTU”.
I-7018Z:
Refer to the previous steps when configuring this module. (As per the picture below)
Configuration Settings:
Address = 2, Baud Rate = 19200, Data Format = Engineering
Channel Enable/Disable Settings:
Take the channel one for example, and set the CH0 to “T/C K-type”.