TPD/VPD Series - Getting Started v.1.0.5
Page 60
Copyright@ 2012 ICP DAS CO., LTD. All Rights Reserved. E-mail: [email protected]
3.4.3
Device Setup (TouchPAD)
The project design is now finished and is ready to be downloaded to the TouchPAD. In
Demo 3, there are two Web series TouchPAD (TPD-283) device that must be configured
and have an IP assigned before downloading the project.
The default settings for the TPD-283 are “IP = 192.168.255.1”, “Gateway = 192.168.0.1”
and “Mask = 255.255.0.0”, as indicated on the label of the shipping container. Of course,
these settings may not be suitable for every environment and may need to be changed.
First, make sure that the hardware network is connected (refer to
Dvices), and then search for the TPD-283 device and set up the IP. Note: Only one
TouchPAD device can be configured at any one time.
Step 1: Set up the TouchPAD IP
a.
Select the “Setup Device (TouchPAD)” option from the “Run” menu to enter the
“Setup Ethernet Device” window.
b.
Click the “Search TouchPAD…” button to search for the TouchPAD on the network. If
your TPD-283 is being set up for the first time or it is on a different sub-domain, move
the rotary switch position to 1 and reset the TPD-283, then begin the search again.
This will take about 40 seconds, and then IP = 0.0.0.0 will be displayed.
c.
Double click the IP field for the device to begin the setup process.
a.
b.
c.