PISO-DNM100 DeviceNet Master API functions User’s Manual (Ver: 1.0) 2008/02/25
19
2.2 Jumper Selection
The following table shows the definition of jumpers or DIP switch. Users
need to refer to this table to configure the PISO-DNM100- D/T hardware.
Jumper
Description
Status
JP1
CAN Port 120
Ω
terminal resistance.
Enable Disable
JP3
Reset pin for download error. If users
want to update firmware but the process
is fail, users can enable this jumper to
reset the PISO-DNM100-D/T into
download mode.
Enable Disable
JP4 None.
None
DIP switch
DIP switch is used to set the PISO-
CM100 board No. Switch1 is for bit0,
switch2 is for bit1 and so forth. For
example, if the left-hand-side switch
(switch 1) is ON, the board No. is set to
1. The range of board No. is from 0 to
15. Be careful that the board No. for
each PISO-CM100-D/T, PISO-
DNM100-D/T and PISO-CPM100-D/T
must be unique.
This situation indicates
the board No. 1.
Table 2.1 Jumper or DIP switch selections
