AM335X-PAC Series User Manual version 2.0.1 Page: 38
Copyright © 2019 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
2.5. LAN1/LAN2 Network Configuration
After logging into the LinPAC
AM335x PAC successfully, the user can use ‘
ifconfig
’ command to get
the IP address of LAN1/LAN2. The LAN 1/2 of factory setting use DHCP. If user would prefer to
setup the IP address for static mode, the following steps for reference:
Step 1: Using the Linux command
‘
vi
’
to modify the file
‘
/etc/network/interfaces
’
.
Step 2:
Using the
‘
#
’
to mark the default configuration.
Remove the
‘
#
’
comment from each line in the static IP block and comment out the DHCP block by
adding
‘
#
’
to each entry. Entry the relevant IP, Netmask and Gateway details in the respective
Assign IP block entries. (Refer to the Figure 2.5-1)
Figure 2.5-1.
Network configuration
Step 3:
After user save the file and use
‘
reboot
’
command to reset the device, user can use the
new network configuration on LinPAC AM335x PAC.
