
34
SETTING SB-110
4
4-1 Turning on SB-110 and PC
Through a hub, connect SB-110 to a PC used for setting.
[Remarks]
◎
In the default setting, a wireless terminal cannot
connect to SB-110 through an access point (
☞
see 4-3).
◎
When you set SB-110, even if SB-110 is used
for several PCs on a network, disconnect one of
those PCs from the network.
◎
The PC used to set SB-110 should be config-
ured according to "Connecting in Building Com-
munication Mode" (
☞
see 3-1). Then, the IP
address of wired terminal is obtained from SB-
110 automatically.
1.
Turn on SB-110 and the hub.
2.
Check that the [PWR] (Green) indicator and [LAN] (Red) indicator turn on. If one of or
both of them turns off, check that the device power supply and cables are connected
correctly.
3.
Turn on the PC connected to the hub.
4.
Check that the IP address is assigned from SB-110 (
☞
3-4).
* When the IP address is not assigned, the SB-110 setting screen cannot be shown.
Check the TCP/IP setting, etc. in "Connecting in Building Communication Mode"
(
☞
3-1) again.
=
×
×
×
×
Wired terminal
SB-110
192.168.0.1
HUB
PDF取説-E̲1 02.1.23 10:28 ページ34
Summary of Contents for SB-110
