19
3
dPMR OPERATION
D
Transmitting a Voice Call
NOTE:
If you want to make a call to the pre-programmed
ID, skip step
q
and
w
, and directly go to step
e
.
q
Push
[dPMR Button]
to enter the ID selection mode.
• The pre-programmed ID is displayed.
w
Push
[CH Up]
or
[CH Down]
to select a desired Individual
ID or Talkgroup ID.
e
Push
[Call]
to make a Voice call.
• “
WAIT
” appears while transmitting.
• “
CONNECT
” is displayed when an acknowledgement is received.
• “
FAILED
” is displayed when no acknowledgment is received.
r
After “
CONNECT
” is displayed, hold down
[PTT]
and
speak into the microphone at your normal voice level. Re-
lease
[PTT]
to receive.
t
After the communication is finished, push
[Clear]
to send
a ‘Disconnect’ signal to terminate the connection.
• Either station can send a ‘Disconnect’ signal.
D
Transmitting a Status Polling Call
The transceiver can send a signal that causes the target sta-
tion to automatically transmit its current status.
q
Push
[dPMR Button]
to enter the ID selection mode.
• The pre-programmed ID is displayed.
w
Push
[CH Up]
or
[CH Down]
to select a desired Individual
ID.
e
Push
[dPMR Button]
again to enter the application selec-
tion mode.
• “
STATUS
” is displayed.
r
Push
[CH Up]
or
[CH Down]
to select “
STAT POL
.”
t
Push
[Call]
to transmit the status polling call to the se-
lected station.
• “
WAIT
” is displayed while transmitting.
• When a status message is received, the message and the sta-
tion’s ID blink.
• “
FAILED
” is displayed when no acknowledgment is received.
After a specified time period, the transceiver will return to the
stand-by mode.
y
Push
[Clear]
to return to the stand-by mode.