![background image](http://html2.mh-extra.com/html/icom/ic-a210e/ic-a210e_instruction-manual_3461962029.webp)
25
5
MENU MODE
D
Beep Tone Level
“BEEP”
Confirmation beep tones normally sound when storing mem-
ory, operating time-out-timer function, etc. These can be set
the desired beep level as you prefer.
• OFF (0) : The beep tone turns OFF.
• 001 to 100 : Setting the beep tone level from 1 to 100.
D
Intercom Usable Setting
“INCOM MODE”
Set the intercom using or not.
• ON
: The intercom is usable.
• OFF
: The intercom is unusable.
D
Time-Out-Timer
“TIME OUT”
To prevent accidental prolonged transmission, the trans-
ceiver has a time-out-timer function. This timer starts when a
transmission begins, and will cut off the transmission when
the time set in the timer elapses.
• 020 to 240 : Setting time-out-timer starting period from 20 sec
-
onds to 240 seconds in 10 seconds intervals.
D
Frequency Step
“FREQ. STEP”
Set the desired frequency step: 8.33 kHz or 25 kHz.
• 25kHz
: Setting the frequency step to 25 kHz.
• 8.33kHz
: Setting the frequency step to 8.33 kHz.
D
Interlock
“INTERLOCK”
When two transceivers are connected together, the interlock
function can prevent them from transmitting at the same
time.
• TX INHIBIT : Transmission is prevented.
• RX MUTE
: Audio output is prevented.
• BOTH
: Transmission and audio output are both prevented.
D
Memory Clear
“MEM CLEAR”
Set values in the CPU are cleared.
Hold down
[MEM]
for 2 seconds, the CPU is reset as fol-
lows.
• MENU
: MENU mode items are reset.
• MEMORY
: Stored memories are reset.
• ALL
: All CPU data is reset.
0
5
NOTE:
When using an external speaker, the beep tone
level when the squelch is closed is fixed and cannot be
changed in the MENU mode.
NOTE:
The interlock does not appear when the “TX/RX
INTERLOCK SW” is set to “DISABLE,” by the CS-A210.
Summary of Contents for IC-A210E
Page 1: ...iA210E VHF AIR BAND TRANSCEIVER INSTRUCTION MANUAL...
Page 34: ...30 9 ABOUT DOC...
Page 38: ...34 MEMO...
Page 39: ...35 MEMO...