10
3
MEMORY OPERATION
n
Programming a memory
channel
To program the memory channels, follow the steps below.
q
Rotate
[DIAL]
and
[O-DIAL]
to set the desired frequency
for the standby frequency.
w
Push
[RCL]
to enter the memory mode.
• The channel number appears.
• The memory channel name also appears if it has been entered.
e
Rotate
[O-DIAL]
to select the desired memory channel
type.
• Select regular channel or group memory channel.
r
Push
[MEM]
, and then rotate
[O-DIAL]
to select the “RE-
PLACE” menu.
• The channel number blinks.
t
Rotate
[DIAL]
to select a channel to be programmed.
y
Push
[MEM]
, to program the frequency into the channel.
• “WRITE COMPLETED” appears on the display when the regu
-
lar memory channel is programmed.
u
Push
[RCL]
to exit the memory mode.
n
Channel selection
The transceiver has 10 channels in the regular memory and
200 channels in the group memory. There are 10 channels
in each of 20 groups (GRP01–GRP20).
q
Push
[RCL]
to enter the memory mode.
• The channel number appears.
• The memory channel name also appears if it has been entered.
w
Rotate
[O-DIAL]
to select the memory channel type.
• Select from regular memory channel or group memory channel.
e
Rotate
[DIAL]
to select the desired memory channel
number.
Transferring the memory channel to the active fre-
quency is necessary if you want to operate on the
memory channel frequency.
Refer to “Transferring memory contents” (p. 12) for
details.
r
Push
[RCL]
to change to standby frequency to the se-
lected memory channel frequency and exit the memory
mode.
CH01
127.00
5
122.00
RX
MEMORY
NOTE:
Hold down
[RCL]
for 2 seconds to exit the mem-
ory mode without changing the previously set standby fre-
quency.
Summary of Contents for IC-A210E
Page 1: ...iA210E VHF AIR BAND TRANSCEIVER INSTRUCTION MANUAL...
Page 34: ...30 9 ABOUT DOC...
Page 38: ...34 MEMO...
Page 39: ...35 MEMO...
