![background image](http://html2.mh-extra.com/html/icom/ic-a210e/ic-a210e_instruction-manual_3461962009.webp)
5
2
BASIC OPERATION
0
1
0
2
n
Frequency selection
IC-A210E has two ways to select the desired frequency.
ï
General frequency selection
Select the desired frequency which is used for the next op-
erating frequency in the standby frequency indicator. Then
exchange the active frequency for the standby frequency.
NOTE:
Operate from “Standby frequency selection (Step
1-2)” to “Frequency exchanging (Step 2-2)” as pages 5, 6.
ï
Direct frequency selection
The desired frequency direct selection is available.
Refer to “Direct frequency selection mode operation.”
n
Standby frequency selection
(Step 1-2)
q
Rotate
[VOL]
clockwise to turn power ON.
• Previously used frequencies appear in the active and standby
frequency indicators.
w
Rotate
[DIAL]
and
[O-DIAL]
to select the desired fre-
quency to the standby frequency.
• The active frequency is not affected.
• Rotate
[O-DIAL]
to set above 1 MHz digit.
• Rotate
[DIAL]
to set below 100 kHz digit.
• Set the frequency step* in the menu mode (p. 25).
*Varies depending on the transceiver version.
TIP:
For quick frequency setting, often used frequen-
cies can be programmed into memory channels. Refer to
“MEMORY OPERATION” (pp. 9–17).
When a memory channel is recalled, the previous standby
frequency is erased.
CAUTION:
DO NOT
turn the power ON until the air-
craft engines have been started. It is very important for
protection of the power supply circuit.
Summary of Contents for IC-A210E
Page 1: ...iA210E VHF AIR BAND TRANSCEIVER INSTRUCTION MANUAL...
Page 34: ...30 9 ABOUT DOC...
Page 38: ...34 MEMO...
Page 39: ...35 MEMO...