![background image](http://html.mh-extra.com/html/icom/ic-400pro/ic-400pro_instruction-manual_612125010.webp)
5
2
BASIC OPERATION
■
Turning power ON
➥
Push [
] to turn the power ON.
■
Channel selection
➥
Push
[
]
/
[
]
to select the desired operating channel.
• While pushing and holding
[
]
or
[
]
, the displayed channel
changes continuously until channel number “01” appears.
• When displayed channel stops at channel number “01”, beeps
are emitted.
D
Private channel selection
q
Push
[
O
]
(Bank/Func) to enter the channel bank selection
mode. Then select the desired bank with
[
]
/
[
]
. Push
[
O
]
(Bank/Func) again to set the bank.
w
Push
[
]
/
[
]
to select the desired operating channel in
sequence.
NOTE:
The selected channel is retained even when the
transceiver is turned off.
Push
[
O
]
Push
[
]
or
[
]
Push
[
]
About the password prompt:
If the transceiver is programmed for a start up passcode,
enter the specified 4-digit code.
(The optional CS-400PRO
CLONING SOFTWARE
is required.)
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
When the “PASSWORD” indication does not clear after
entering 4 digit code, the enter code number is incorrect. In
this case, turn the power off and start over.
KEY
NUMBER
0
1
2
3
4
5
6
7
8
9
IC-400PRO.qxd 03.6.19 6:13 PM Page 5 (1,1)
Summary of Contents for IC-400PRO
