NI-7075349
Wireless Router 300N
- 68 -
4.12.1 Static Routing
Choose menu “Advanced Routing
→
→
→
→
Static Routing”, and you can configure the static route in
the next screen, shown in Figure 4-62. A static route is a pre-determined path that network
information must travel to reach a specific host or network.
Figure 4-62 Static Routing
To add static routing entries, follow the steps below.
1. Click Add New… shown in Figure 4-62, you will see the following screen Figure 4-63.
Figure 4-63 Add or Modify a Static Route Entry
2. Enter the following data.
Destination Network - The Destination Network is the address of the network or host
that you want to assign to a static route.
Subnet Mask - The Subnet Mask determines which portion of an IP Address is the
network portion, and which portion is the host portion.
Default Gateway - This is the IP Address of the default gateway device that allows for the
contact between the Router and the network or host.
3. Select Enabled or Disabled for this entry on the Status drop-down list.
4. Click the Save button to make the entry take effect.
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
