Installation
27
–
following a cross pattern, swap the socket ring nut of a hinge (8) with the opposite drilled one (1),
–
fix the conical washer (4) to the door with nut (2)
–
repeat the whole sequence for the other ring nuts
Sx
DX
1
8
Check the correct adjustment of the tie-rods and hinges ensuring that, during closure, the seal gasket is evenly pressed in the
centre on the whole circumference. If necessary, adjust the door as described in the following paragraph.
FRONT DOOR ADJUSTMENT
a
DANGER
Incorrect door adjustment with consequent damage to people and property voids the warranty conditions.
1
9
2
3
4
6
7
8
5
8
Dx
Sx
ASX 200÷1200
ASX 200÷1200
ASX 1500÷3000
ASX 1500÷3000
1
VERTICAL ADJUSTMENT
To make the adjustment:
–
with the door ajar, loosen the counter-nuts (1) of the hinge units
–
act on the adjustment nuts (2) to lift or lower the door by centring the gasket on the stop plate, then block the counter-nuts
(1)
–
close the door and centre the tie-rod (4) on the mechanical tube (5), proceeding as in the previous point.
1
2
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
