Residual Risk Management
43
TAMPERING
–
The accessories must not be tampered with (safety valve, pressure switches, electric panel or level probes). The generator
must be operated by qualified personnel. In case of accident due to tampering, the manufacturer accepts no liability.
DECOMMISSIONING
–
Periodical check by the operator, as stated in the Technical Manual, and appliance decommissioning, if necessary.
–
Any derating and/or change of use are subject to the prior authorisation of the responsible body.
–
The manufacturer shall not be held liable in the event of accidents caused by incorrect decommissioning.
HANDLING
–
During handling, always stay at a distance of at least 5 metres from boiler projection to the ground.
–
Visually inspect generator to make sure that all its parts and accessories are intact; perform the hydraulic test once again.
–
Handle the generator in compliance with the indications set forth in the manual.
FIRE
–
The plant room must be arranged in compliance with the fire protection regulations in force in the country of installation.
–
Check that body and accessories are intact and not damaged after the fire.
UNIT POOR MANAGEMENT
–
The operator must meet the requirements provided by the prevailing standards in the country of installation.
–
The user is anyway obliged to make sure that the generator operator meets all the requirements specified in the previous
point.
SAFETY SYSTEM CHECKS
–
The personnel (refer to the user's manual) must strictly comply with all the indications/prescriptions defined in the relevant
instruction manual and declared by the manufacturer, as well as with the preset time intervals.
–
Carry out operational tests of the safety devices at the times and with methods specified in the manuals.
–
Generator control system triggers a visual and acoustic alarm at the intervals specified in the instructions for use.
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
