Connecting to Data Service with USB connection
After USB driver has been installed, you must use AxessManager to configure
and connect the Modem to the network. Please refer to AxessManager
Operational Guide chapter for detailed instructions. Make sure the Modem
selector switch is set to USB position before attempting the connection.
Normally Windows OS will automatically detect your Modem USB
connection after you have installed AxessManager. If for some reasons Windows
OS failed to complete this task, you may need to perform the following
steps after installing AxessManager to fully configure your Modem in USB mode.
1. Verify in Network Connection window that
USB connection has been created in “Dial up” section.
The connection name is set by your service provider
(default name is 1xEvDO). You can also find the
connection name in AxessManager utility, USB
Connection Profile tab
2. If no USB connection appears in Dial up
section, go to AxessManager utility, USB Connection
Profile tab, highlight the connection name your service
provider has created, click
Edit
, insert user-ID “cdma”,
password “cdma” and dial #777. Click OK to accept the
set up. This will add the connection to the Network
Connection window, select Dial up connection.
3. In very rare cases, Windows OS may associate
the wrong modem to your Dial up connection. To verify,
right click on the Dial up connection name in step 1
above and select
Properties
. You should see the
Axesstel USB Modem selected and the correct dial
number entered. If notupdate the fields with correct
value.
23
