16
•
Quick Installation Guide
•
The Install Software CD with User Manual
•
The Modem
•
The Modem’s Power Supply
•
RJ-45 Ethernet Networking Cable
1.3 Turn off any firewall or Internet-connection-sharing software on your
computer.
1.4 Insert the Install software CD into your CD-ROM drive. The Installation
screen will automatically appear on your screen within 15 seconds. If it
does not, select your CD-ROM drive from “My Computer” and double-click
on the file named “EasyInstall.exe” on the CD-ROM.
Step 2
│
Set up the Hardware
2.1. Make sure your Modem is not connected to any power source and all the
LED are OFF.
2.2 Locate the RJ-45 Ethernet cable that is included with your Modem. Plug
one end of this cable into ANY one of the Ethernet ports on your Modem.
Plug the other
end of the cable into the networking port on your computer.
2.3 Locate the power supply that is included with your Modem. Plug the power
supply’s small connector into the power port on the Modem. Plug the
power supply into an empty power outlet.
2.4 Switch on the Modem. Look at the Power LED on top of the Modem and
make sure the lights are ON.
2.5 Wait for a few seconds for the Modem to search for service network. Once
the Modem finds a suitable network, observe the Signal LED turns to Red,
Orange or Green depending on the strength of acquired signal. Refer to
the Signal Strength LED description for more details.
Step 3
│
Preparing your PC
Your Modem’s Ethernet is configured with DHCP by default. This means that IP
address of your PC is automatically assigned by the Modem. Make sure that
your PC has the correct TCP/IP setting for its "Local Area Connection" by
following the steps below.
