IBM xSeries 230 61Y, Hardware Maintenance Manual

Page: 58 / 194

1
Top cover
2
Right side latch
3
Cover release lever
4
Left side latch
To remove the server top cover:
1. Review the information in “Before you begin” on page 47.
2. If you are planning to install or remove any part other than a hot-swap hard
disk drive or hot-swap power supply, turn off the server and all attached
devices and disconnect all external cables and power cords.
3. Release the left and right side latches and pull the server out of the rack
enclosure until both slide rails lock.
Note: When the server is in the locked position, you can reach the cables on
the back of the server.
4. Move the cover-release lever down while sliding the top cover toward the rear
of the server about 25 mm (1 inch). Lift the cover off the server and set the
cover aside.
Attention: For proper cooling and airflow, replace the cover before turning on
the server. Operating the server for extended periods of time (over
30 minutes) with the cover removed might damage server
components.
Removing the server door (tower model)
1
Release tab
2
Door
3
Flange
To remove the server door:
1.
Unlock and open the server door.
2. Locate the flange on the top edge of the door.
50
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y