IBM xSeries 230 61Y, Hardware Maintenance Manual

Page: 36 / 194

d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
3. Insert the new battery:
a.
Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
4. Reinstall the server cover and connect the cables.
Note: Wait approximately 20 seconds after you plug the power cord of your
server into an electrical outlet for the Power Control button to become
active.
5.
Turn on the server.
6. Start the Configuration/Setup Utility program and set configuration
parameters.
v
Set the system date and time.
v Set the power-on password.
v
Reconfigure your server.
Temperature checkout
Proper cooling of the system is important for proper operation and system
reliability. For a typical Netfinity server, you should make sure:
v
Each of the drive bays has either a drive or a filler panel installed
v
Each of the power supply bays has either a power supply or a filler panel
installed
v
The top cover is in place during normal operation
v
There is at least 50 mm (2 inches) of ventilated space at the sides of the server
and 100 mm (4 inches) at the rear of the server
v The top cover is removed for no longer than 30 minutes while the server is
operating
v
The processor housing cover covering the processor and memory area is
removed for no longer that ten minutes while the server is operating
v
A removed hot-swap drive is replaced within two minutes of removal
v
Cables for optional adapters are routed according to the instructions provided
with the adapters (ensure that cables are not restricting air flow)
28
Hardware Maintenance Manual: xSeries 230 Models 6RY, 61Y