IBM xSeries 200VL, Installation Manual

Page: 33 / 70

Chapter 2. Installing options
21
Be sure that the retaining clips snap into the locked position when the DIMM
is firmly seated in the connector.
f. If a gap exists between the DIMM and the retaining clips, the DIMM has not
been properly installed. In this case, open the retaining clips and remove the
DIMM; then, reinsert the DIMM.
g. If you removed the AGP video adapter, reinstall it now. See “Installing an
adapter” on page 12.
5. If you have other options to install or remove, do so now.
6. Replace the support-bracket assembly and reconnect the fan cable to the
connector (SYSFA3) on the system board. See “Removing the support-bracket
assembly” on page 10 and “System board internal cable connectors” on page 5
for the location of the fan cable connector.
7. Replace the side cover. See “Installing the cover” on page 22.
8. Reconnect the external cables and power cords; then, turn on the peripheral
devices and the server.
If you want to remove a DIMM, reverse these steps.
Installing a security U-bolt
To help prevent hardware theft, you can add a security U-bolt and cable to your server.
After you add the security cable, make sure that it does not interfere with other cables
that are connected to the server.
Before you begin:
• Obtain the following items:
— A flat-blade screwdriver
— An adjustable wrench
— A 19 mm (0.75 in.) U-bolt or wire rope (similar to National Manufacturing No.
3230, Stock No. 176-735)
— Threaded nuts that fit the U-bolt
— A security cable