IBM xSeries 200VL, Installation Manual

Page: 32 / 70

20
IBM xSeries 200 and xSeries 200VL: Installation Guide
Complete the following steps to install a DIMM.
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 3.
1. Review the safety precautions listed in “Safety” on page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the cover (see “Removing the side cover” on page 9
for details).
3. Remove the support-bracket assembly and disconnect the fan cable from the
connector (SYSFA3) on the system board. See “Removing the support-bracket
assembly” on page 10 for details. See “System board internal cable connectors”
on page 5 for the location of the fan cable connector.
4. Install the DIMM:
a. If you are installing a DIMM in connector 1, remove the AGP video adapter.
Remove the AGP video adapter only if you are replacing the DIMM in
connector 1. See “Working with adapters” on page 11 for the location of the
AGP slot.
b. Open the retaining clip on each end of the DIMM connector.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
c. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the server. Then, remove the DIMM from the package.
d. Turn the DIMM so that the pins align correctly with the connector.
e. Insert the DIMM into the connector by aligning the DIMM edges with the slots
at each end of the DIMM connector. Firmly press the DIMM straight down into
the connector by applying pressure on both ends of the DIMM simultaneously.
DIMM connector 1
DIMM connector 2
DIMM connector 3
Retaining clip