IBM xSeries 200VL, Installation Manual

Page: 22 / 70

10
IBM xSeries 200 and xSeries 200VL: Installation Guide
Removing the support-bracket assembly
When working with some options such as hard disk drives, microprocessors, and
memory modules, you must first remove the support-bracket assembly to access the
location of the option.
Complete the following steps to remove the support-bracket assembly.
1. Review the safety precautions listed in “Safety” on page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then, remove the side cover. See “Removing the side cover” on
page 9 for details.
3. Disconnect the support-bracket assembly fan cable from the connector (SYSFA3)
on the system board. For the location of the fan cable connector, see “System
board internal cable connectors” on page 5.
4. Locate the end of the support-bracket assembly near the rear of the server. Pull it
out approximately 152.4 mm (6 in.).
5. Pull the front end of the support-bracket assembly away from the server and place
the assembly aside.
To reinstall the support-bracket assembly, reverse these steps.