IBM xSeries 200VL, Installation Manual

Page: 35 / 70

Chapter 2. Installing options
23
Complete the following steps to install the server cover.
1. Clear any cables that might impede the reinstallation of the cover.
2. Install the side cover:
Note: The cover-release latch must be in the unlocked (opened) position before
reinstalling the cover on the sever.
a. Insert the tabs located inside the cover into the slots located on the server
chassis.
b. Close the cover-release latch to secure the cover in place.
Note: Make sure each tab on the cover is in its corresponding slot before closing
the cover-release latch.
3. Lock the cover.
4. If you have not done so already, make sure the stabilizing feet are in the
stabilizing position so that they properly support the server. See “Moving the
stabilizing feet” on page 7.
5. Reconnect the external cables and power cords to the server, and then plug the
power cords into properly grounded electrical outlets.
6. Turn on the peripheral devices; then, turn on the server.
Cabling the server
Note: The illustrations in this document might differ slightly from your hardware.
If your server cables and connector panel have color-coded connections, match the
color of the cable end with the color of the connector. For example, match a blue cable
end with a blue panel connector, a red cable end with a red connector, and so on.
The following illustration shows the I/O connectors on the rear of the server.
Power cord
connector
Mouse
Keyboard
Parallel
Serial 1
Serial 2
USB 2
USB 1
Mic
MIDI
Line in
Line out
Ethernet
Video