IBM xSeries 100, Problem Determination And Service Manual

Page: 79 / 126

Removing a memory module
To remove a dual inline memory module (DIMM), complete the following steps.
DIMM
Retaining
clip
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 55.
2. Turn off the server and all peripheral devices; then, disconnect the power cords
and all external cables.
3. Remove the cover (see “Removing the cover” on page 57).
4. Disconnect any cables that impede access to the DIMMs.
5. Locate the DIMM connector that contains the DIMM to be replaced (see
“System-board option connectors” on page 7 for DIMM slot locations).
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
6. Carefully open the retaining clips on each end of the DIMM connector and
remove the DIMM.
7. If you are instructed to return the DIMM, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing server components
63