IBM Universal Tape Library, User Manual, Page: 56 / 96

Installing a power supply
To install a library power supply, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 7.
2. Make sure that the library is turned off and that the power cord is disconnected.
3. Slide the power supply into the library chassis.
4. Tighten the captive screw.
5. Install the power cord.
Removing a magazine
To remove a magazine, complete the following steps:
1. From the main screen, press the Ops button.
2. From the Ops menu, press the Down (
↓
) button to select Library Operations (if
it is not already selected), and press the Enter button. The Library Ops menu is
displayed.
3. Press the Down button to select Release Magazines . The magazine doors
open, and the magazines are released.
Attention: Use care when you remove a magazine with cartridges installed.
The magazine is heavy and will drop when it is removed from the library.
4. Pull the magazine out of the library.
5. Remove the tapes from the magazine.
6. Remove the three Phillips screws that secure the magazine handle to the
magazine.
Captive screw
Figure 20. Removing a power supply
46
Universal Tape Library User’s Guide