IBM Turbo 16/4 Token-Ring PC Card 2, User Manual

Page: 98 / 123

One of the following codes will be shown to indicate the results of the initialization
test. The error codes are displayed in hexadecimal format and represent the
BRING_UP_CODE set by the adapter.
0000 Initialization success
0014 No microcode
0020 Diagnostics could not be executed
0022 ROM diagnostics failed
0024 Shared RAM diagnostics failed
0026 Processor instruction test failed
0028 Processor interrupt test failed
002A Shared RAM interface register diagnostics failed
002C Protocol-handler diagnostics failed
0040 PC Card’s programmable timer for the computer failed (set by the
microcode)
0042 Cannot write to shared RAM (set by microcode)
0044 Reading from shared RAM read-only area caused an incorrect error
indication (interrupt)
0046 Writing into shared RAM read-only area did not cause an error indication
(interrupt)
0048 Initialization timed out
Open Errors
Failure during the adapter open test might indicate that the adapter is not properly
configured to run on the network it is trying to open onto or that the adapter is not
properly configured for the system. The open test provides a return code and an
open error code. If the return code is 07, then see “Open Error Codes” on page 83
for a more accurate description of the failure and suggested actions. If the return
code is a value other than 00 or 07, problem determination of the PC Card and the
diagnostics is necessary. Record the error and contact your network administrator.
00 Open completed successfully
01 Incorrect command code
03 Adapter open, should be closed
05 Required parameters not provided
07 Command cancelled, unrecoverable failure (see open error codes to isolate
problem)
30 Inadequate receive buffers
32 Incorrect MAC address
33 Incorrect adapter receive buffer length
34 Incorrect adapter transmit buffer length
82
Turbo 16/4 Token-Ring PC Card 2