IBM TotalStorage SAN Volume Controller, Installation Manual

Page: 79 / 123

2
latch-lock
3
latch-lever
6. Put your index finger against the side of the latch lever
3
and your thumb
against the front of the latch lock
2
.
7. Gently push the latch lock
2
away form the rail as you move the latch-lever
3
towards the front of the rail. The latch-lock carrier assembly slides against
the spring tension.
8. Release the latch lock and continue to slide the latch-lock carrier for
approximately 13 mm (0.5 in). The latch lever engages in a hole in the back
bracket assembly and holds the latch-lock carrier in the retracted position.
9. Place the front end of the left rail in the rack cabinet. Align the top of the front
bracket
1
(Figure 25) with the required EIA marking that is on the rack.
1
front bracket
2
rack-mounting flange
3
locating pins
10. Align the locating pins
3
with the holes that are in the rack-mounting flange
2
.
11. Push the latch lock
2
(Figure 26 on page 50) away from the rail to release the
carrier. The latch-lock carrier slides toward the front of the rack, and the
locating pins project through the holes that are in the front flange and in the
front rail bracket.
1
2
3
Figure 25. Installing the front end of the rail
Chapter 3. Installing the uninterruptible power supply and the SAN Volume Controller
49