IBM TotalStorage SAN Volume Controller, Installation Manual

Page: 80 / 123

Important: Ensure that the locating pins are fully extended through the front
rail bracket.
1
latch-lever
2
latch-lock
12. Push the back rail bracket
1
(see Figure 24 on page 48) toward the rear of
the rack and align the locating pins with the rack-mounting flange.
13. Push the latch lock
2
(see Figure 24 on page 48) away from the rail to release
the carrier. The latch-lock carrier slides toward the rear of the rack, and the
locating pins project through the holes that are in the rear flange and in the
rear rail bracket.
Important: Ensure that the locating pins are fully extended through the rear
rail bracket.
14. On the rear of each rail, press the blue release tab and slide the shipping
bracket off the slide rail. Store the shipping bracket for further use.
Installing the SAN Volume Controller in the rack
After installing the support rails, you are ready to install the SAN Volume Controller
in the rack.
Before you install the SAN Volume Controller in the rack, read the following caution
notice.
1
2
Figure 26. Closing the latch-lock carrier assembly
50
IBM TotalStorage SAN Volume Controller: Installation Guide