IBM TotalStorage IP Storage 200i 110, Installation Manual

Page: 21 / 94

7. Use the M6 screws to attach the hinge bracket to the rear of the rack. Then,
use the hinge pin to attach the cable-management assembly to the slide rail.
1
2
8. Fully extend the slide rails out of the rack.
9. Lift the engine above the rails. Then, rest the rack-support wheels, located near
the rear of the engine, on the slide rails.
10. Lower the front of the engine onto the slide rails.
Note: Be sure that the bracket notches on the front of the engine fit securely
on the tabs located on the front of the slide rails.
A
B
C
1
2
11. Use the M4 screws to secure the engine to the rails. Unscrew the rear
rack-support wheels and store them in a safe place.
A
1
2
12. Replace the rack door and side panels, if necessary.
13. Replace the hard disk drives in the engine:
a. Ensure that the tray handle is open (that is, perpendicular to the hard disk
drive).
b. Align the rails on the hard disk drive assembly with the guide rails in the
drive bay.
Chapter 2. Installation procedures
9