IBM TotalStorage IP Storage 200i 110, Installation Manual

Page: 38 / 94

Installing the Tower-to-Rack Kit
Refer to the instructions that come with your Tower-to-Rack Kit for information on
converting a tower model to a rack-mountable model.
Attaching the cables
This section describes how to attach the power and network cables to your
appliance.
Model 110
To attach the cables:
1. For each of the three power cords, connect the appropriate end of the power
cord to a power supply and the opposite end to a properly wired and grounded
electrical outlet.
2. Connect one end of the Gigabit Ethernet cable to the Gigabit Ethernet adapter
located in expansion slot 4, and connect the opposite end to the system
network.
Note: You may use a 10/100 Ethernet cable if your network does not support
Gigabit Ethernet.
1 2 3
2
1
3. Route the power and network cables through the cable-restraint bracket on the
rear of the engine by opening the bracket and threading the cables through the
slots in interior of the bracket, and close the bracket.
26
IBM TotalStorage IP Storage 200i Models 110 and 210 Installation Guide