IBM TotalStorage IP Storage 200i 110, Installation Manual

Page: 39 / 94

Model 210
To attach the cables:
1. Press the safety latches and slide the engine halfway into the rack.
2. For each of the three power cords, connect one end of the power cord to a
power supply and the opposite end to a properly wired and grounded electrical
outlet.
3. Connect one end of the Gigabit Ethernet cable to the Gigabit Ethernet adapter
located in expansion slot 4, and connect the opposite end to the system
network.
Note: You may use a 10/100 Ethernet cable if your network does not support
Gigabit Ethernet.
4. Route the power and network cables through the cable-restraint bracket on the
rear of the engine by opening the bracket and threading the cables through the
slots in the interior of the bracket, and close the bracket.
5. Slide the engine into the rack until the safety latches snap shut.
6. Route the cables through the cable-management assembly on the rack.
Chapter 2. Installation procedures
27