IBM TotalStorage FAStT600, Installation And User Manual

Page: 63 / 134

1. Wrap the strain-relief clamp around the power cord approximately 20 cm (8 in.)
from the power supply connection end.
2. Attach the power-supply nut, and tighten it securely.
3. Connect the power cord to the power supply.
4. Plug the power cord into a properly grounded electrical outlet.
Note: To maintain power redundancy, plug the FAStT600 Storage Server’s right
and the left power supplies into two independent external power circuits
through ac distribution units inside a rack cabinet or directly into external
receptacles. Similarly, the right and left power supplies of the FAStT drive
enclosures attached to the FAStT600 Storage Server should be plugged
into the same two independent external power circuits as the FAStT600
Storage Server. See Figure 32 on page 34 for an example of redundant
power cabling.
AC power
connector
AC power
switch
Strain-relief
clamp
Lever
-
Figure 31. Power cord locations
Chapter 3. Cabling the storage server
33
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|