IBM TotalStorage FAStT600, Installation And User Manual

Page: 96 / 134

c. With the SFP latch in the unlocked position, extract the SFP module.
v For SFP modules that contain plastic tabs, slide the SFP module out of
the port.
v
For SFP modules that contain wire tabs, grasp the wire latch and pull
the SFP module out of the minihub port.
d. Replace the protective cap on the SFP module.
e. Place the SFP module into a static-protective package.
f. Replace the protective cap on the port.
5. Remove the failed RAID controller (the Fault LED is on), as follows:
a. Push down on the latch (centered above the RAID controller). Pull both
levers at the same time out of the locked position.
b. Grasp the pull-rings; then pull on the levers and remove the RAID
controller.
6. To remove the cache battery, place the RAID controller CRU bottom up on a
flat surface. Using a #2 Phillips head screwdriver, remove the six screws (three
on each side of the RAID controller) that hold the RAID controller bottom panel
to the sides of the RAID controller, as shown in Figure 54 on page 67.
Protective cap
SFP module
90
o
Wire tab
Figure 52. Unlocking the SFP module latch - wire variety
Figure 53. Pull-rings for removing a controller
66
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User’s Guide