IBM ThinkPad 760E, Manual

Page: 191 / 331

Installing OS/2 Software
Note:
If you have the OS/2 Warp FixPak
10 (XR0010) or later, install it after
you complete the installation of OS/2
Warp. Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
8
Follow the instructions on the screen until the installation is
complete.
Pay attention to the following during installation:
Select VGA as the Primary Display at the System
Configuration screen.
Select No Support Installed, not PCMCIA Feature, at the
System Configuration screen.
Select Non-Listed IDE CD-ROM for the CD-ROM at the
System Configuration screen.
9
Shut down OS/2 and restart the computer.
Installing OS/2 Warp Using the Internal CD-ROM and Diskette Drive
Note:
The following terms are used in
these instructions:
[ cd:] Your CD-ROM drive letter,
followed by a colon
[
c:]
Target hard disk drive letter,
followed by a colon
Have ready two formatted, blank 1.44MB diskettes before
installation.
1
Ensure that you have installed DOS and Windows, and have at
least 90MB of free space on the hard disk drive.
2
Insert the OS/2 Warp CD-ROM into the internal CD-ROM drive.
3
Open the DOS command prompt; then enter the following to
copy all the diskette images from the OS/2 Warp CD-ROM to
the hard disk drive (do not type the [ ] brackets):
xcopy [cd:]\os2image\ . [c:]\os2image\ . /s
copy [cd:]\diskimgs\ . [c:]\os2image
copy [cd:]\diskimgs\os2\35\disk .dsk [c:]\os2image
copy [cd:]\diskimgs\os2\35\disk1.dsk [c:]\os2image
4
Shut down OS/2 and turn off the computer.
Chapter 7. Installing Software
173