IBM System Storage TS7600 ProtecTIER Series, Installation Roadmap Manual

Page: 167 / 232

Table 43. Example auto-detected system information
ID
Target Network
Address
Target Netmask
Local Gateway
Address
1 10.11.194.0 255.255.255.0 10.11.195.1
2 10.11.196.0 255.255.255.0 10.11.197.1
Important: This information is only an example. The information that
displays will be specific to your system, and will be different.
Followed by the Available Options prompt:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
15. Type: a <enter>
You are prompted to enter information for the first destination (target - eth2
for VTL, eth7 for OpenStorage) server and the local network.
Attention:
Do not configure the replication ports Eth2 and Eth5 (VTL) or
Eth7 and Eth11 (OpenStorage) on the same subnet as the external LAN port
Eth0. Doing so may cause replication errors.
16. At each prompt, type the requested information and then press <enter>:
Attention:
In this step, the term "target" refers to the remote node's network
address and netmask (not necessarily the replication "target" server for this
entry.)
Please provide the following information:
Target Network Address:
(starting network address) (for example: 10.11.194.0)
Target Network Netmask:
(for example: 255.255.255.0)
Local Gateway Address:
(the gateway IP address of the server you are currently configuring) (for
example: 10.11.195.1)
A summary displays:
Table 44. Example summary for first server and local network
ID
Target Network
Address
Target Netmask
Local Gateway
Address
1 10.11.194.0 255.255.255.0 10.11.195.1
Important: The addresses in the summary above are examples. Actual values
will vary. For example, if the Target Network Address for the destination
server is 10.11.194.75, its starting address would be 10.11.194.0. For the Local
Gateway Address you would use the gateway address of the source server
(this server).
The Available Options prompt displays a second time:
Chapter 12. Upgrading ProtecTIER to a cluster
129