IBM QS22 - BladeCenter - 0793, Installation And User Manual

Page: 52 / 114

4. Reinstall the blade server into the BladeCenter unit. See Chapter 3, “Installing
the blade server,” on page 15 for further information.
5. Turn on the blade server. See “Turning on the blade server” on page 9 for
further information.
6. If you have replaced the battery or the system board assembly, reset the
system date and time through the operating system that you installed. For
additional information, see your operating system documentation.
Note: If you have just powered on the BladeCenter unit, wait until the power on
LED on the blade server flashes slowly before powering on the blade server.
Installing the front bezel assembly
Figure 25 shows how to install the front bezel assembly on the blade server.
Complete the following steps to install the blade server front bezel assembly:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. Connect the control panel cable to the control panel connector on the system
board assembly.
3. Carefully slide the front bezel assembly onto the blade server, as shown in
Figure 25, until it clicks into place.
Note: Make sure that you do not pinch any cables when you reinstall the front
bezel assembly.
Control-Panel
Cable
Bezel release
Bezel assembly
Blade cover
Control-Panel
Connector
Cover release
Cover release
Bezel release
Figure 25. Installing the front bezel assembly
36
BladeCenter QS22 Type 0793: Installation and User’s Guide