IBM QS22 - BladeCenter - 0793, Installation And User Manual

Page: 51 / 114

b. Use your thumb and index finger to lift the battery from the socket.
c. Dispose of the battery as required by local ordinances or regulations.
7. Insert the new battery:
a. Make sure the positive (+) side is facing upwards.
b. Tilt the battery so that you can insert it into the socket, under the battery
clip.
c. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
8. Close the blade server cover and insert the blade server into the BladeCenter
unit (see “Closing the blade server cover” on page 37 and Chapter 3,
“Installing the blade server,” on page 15).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
9. Turn on the blade server (see “Turning on the blade server” on page 9).
10. Reset the system date and time through the operating system that you
installed. For additional information, see your operating system documentation.
Finishing the installation
To complete the installation you must:
1. Reinstall the front bezel assembly on the blade server if removed. See
“Installing the front bezel assembly” on page 36 for further information.
2. Ensure that the I/O buffer DIMM slots are occupied either by DIMMs or by
DIMM fillers. No DIMM fillers are needed for empty system memory DIMM slots.
3. Replace and close the blade server cover, unless you installed an optional
expansion unit that has its own cover. See “Closing the blade server cover” on
page 37 for further information.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
Chapter 4. Installing and removing replaceable units
35