IBM Netfinity 4500R, User Reference Manual

Page: 133 / 198

Chapter 7. Solving problems
121
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the server without the adapters,
reinstall each adapter one at a time and retest after each is reinstalled.
When an adapter fails, replace it.
If the problem persists, call for service.
01295085 The ECC checking hardware test failed.
Action: Call for service.
01298001 No update data is available for processor 1.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server.
01298002 No update data is available for processor 2.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server.
01298101 The update data for processor 1 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors
installed in the server.
01298102 The update data for processor 2 is incorrect.
Action:
Update the system BIOS to a level that supports the microprocessors
installed in the server.
01298200 Microprocessor speed mismatch
Action: The microprocessors installed do not run at the same speed; install
microprocessors with identical speeds.
I 9990301 A hard disk drive error occurred.
Action: Call for service.
I 9990305 POST could not find an operating system.
Action: Install an operating system. If you have already installed the operating
system, check the drive startup sequence. If the drive sequence is correct,
run the diagnostic tests to verify that the hard disk drive is functioning
correctly. If there is a problem with the hard disk drive (such as a bad
sector), you might need to reinstall the operating system.
If you cannot reinstall the operating system, call for service.
I9990650 AC power has been restored.
Action: No action is required. This message appears each time AC power is
restored to the server after an AC power loss.
Other Numbers POST found an error.
Action: Follow the instructions on the screen.
POST message Description
Table 15. POST error messages