IBM Netfinity 1000, Installation Instructions Manual

Page: 24 / 44

4. Install the memory module:
a. Turn the memory module (DIMM)
.13/
so that the pins align correctly with the connector
.5/
.
b. Insert the DIMM into the connector by pressing on one edge of the DIMM and then on the other
edge of the DIMM. Be sure to press straight into the connector. The retaining clips
.4/
will snap
into the closed positions.
c. Make sure the retaining clips
.4/
are in the closed position. If a gap exists between the DIMM
and the retaining clips, the DIMM has not been properly installed. In this case, open the retaining
clips and remove the DIMM; then, reinsert the DIMM.
d. Repeat these steps for each memory module that you install.
5. Install the memory board:
a. Hold the memory board by the top edge and align the memory board over the memory board
connector.
b. Press on the top edge of the memory board, insert the memory board into the connector, and
tighten the thumbscrew to secure.
6. Go to “Installing the processor housing.”
Installing the processor housing
Complete this procedure to install the processor housing.
1. If slot 6 contains an adapter, move the adapter to an empty slot. If slot 5 contains a full-size adapter,
move the adapter to an empty slot. (Only half-size adapters will fit in slot 5.)
2. Remove the slot 5 and 6 plastic guides opposite the bulkhead.
3. If you have installed the SCSI Controller-to-Bulkhead Cable option, remove the option and replace it
with the SCSI controller-to-bulkhead cable contained in this option:
a. Detach the SCSI cable from the SCSI connector on the system board.
b. Remove the screws from the external connector on the bulkhead opening.
16
Processor Upgrade Instructions