IBM Netfinity 1000, Installation Instructions Manual

Page: 19 / 44

Installing a microprocessor kit
The following table shows the order in which microprocessors and VRMs must be installed.
Table 1. Microprocessor and VRM Installation Order
Note: A terminator card must be installed in each microprocessor connector that does not contain a microprocessor.
One Microprocessor Installed in J1
J12
(VRM 1) J13
(VRM 2) J14
(VRM 3) J16
(VRM 4) J17
(VRM 5) J18
(VRM 6)
Installed Installed
Two Microprocessors Installed in J1 and J4
J12
(VRM 1) J13
(VRM 2) J14
(VRM 3) J16
(VRM 4) J17
(VRM 5) J18
(VRM 6)
Installed Installed Installed Installed
Three Microprocessors Installed in J1, J2, and J4
J12
(VRM 1) J13
(VRM 2) J14
(VRM 3) J16
(VRM 4) J17
(VRM 5) J18
(VRM 6)
Installed Installed Installed Installed Installed
Four Microprocessors Installed in J1, J2, J3, and J4
J12
(VRM 1) J13
(VRM 2) J14
(VRM 3) J16
(VRM 4) J17
(VRM 5) J18
(VRM 6)
Installed Installed Installed Installed Installed Installed
Refer to the following illustrations of the processor housing and processor board that come with this option
while you perform the steps in this procedure.
.1/
Processor housing cover
.2/
Quarter-turn fasteners
Upgrade installation
11