IBM Netfinity 1000, Installation Instructions Manual

Page: 20 / 44

.3/
Latches
.4/
Second installed microprocessor (CPU or processor 4)
.5/
First installed microprocessor (CPU or processor 1)
.6/
Microprocessor connector 1 (J1)
.7/
Microprocessor connector 2 (J2)
.8/
Microprocessor connector 3 (J3)
.9/
Microprocessor connector 4 (J4)
.1ð/
Terminator card
.11/
VRM connectors 5 (J17) and 6 (J18)
.12/
VRMs for second microprocessor (VRMs 5 and 6)
.13/
VRMs for first microprocessor (VRMs 1 and 2)
Complete this procedure to install a microprocessor in the processor housing that comes with this option.
1. Determine the connectors where the microprocessor and VRMs are to be installed. See Table 1 on
page 11.
2. Turn the quarter-turn fasteners
.2/
and remove the processor housing cover
.1/
.
3. Pull on the fasteners and remove the fan assembly.
4. If the microprocessor connector
.9/
contains a microprocessor terminator card
.1ð/
, remove the
terminator card from the microprocessor connector.
5. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to any
unpainted metal
surface on the processor housing; then, remove the microprocessor from the package.
b. Hold the microprocessor
.4/
by the open latches
.3/
, and center the microprocessor over the
microprocessor connector
.9/
.
Attention: Make sure the microprocessor is oriented and aligned correctly before you try to close
the latches.
c. Press the microprocessor into the connector and carefully close the latches
.3/
to seat the
microprocessor in the connector.
12
Processor Upgrade Instructions