IBM Netfinity 1000, Installation Instructions Manual

Page: 22 / 44

Installing memory-module kits
You install memory-module kits on the memory board included in the Processor Upgrade Kit.
Notes:
1. Install memory modules in connectors J1, J5, J2, J6, J3, J7, J4, and J8, in that order. (See the
illustration on the next page for memory connector locations.)
2. If you mix DIMM sizes, install the largest sized DIMM in connector J1, the next largest sized DIMM in
connector J2, and so forth, to enhance memory-module performance.
3. Installing or removing memory modules changes the configuration information in the server.
Therefore, after installing or removing a DIMM, you must save the new configuration information in the
Configuration/Setup program. When you restart the server, the system displays a message indicating
that the memory configuration has changed. Start the Configuration/Setup Utility program and select
Save Settings.
Refer to the following illustrations of the processor housing and the processor board while you perform the
steps in this procedure.
.1/
Thumbscrew
.2/
Memory board
.3/
Memory board handle
14
Processor Upgrade Instructions