IBM G27, User Reference

Page: 161 / 200

Table 27. Power-supply LED errors (continued)
AC good LED DC good LED Description Part/action
On Off Standby mode or dc
problem.
1. Check system board cable connectors J4
and J10. Move switch 7 of SW 1 to bypass
power control. If the dc good LED is lit,
press Ctrl+Alt+Delete. Watch the screen for
any POST errors. Check the System Error
Log for any listed problems. If the system
starts with no errors:
a. Power switch assembly
b. System board
2. Remove the adapters and disconnect the
cables and power connectors to all internal
and external devices. Turn on the system.
If the dc good LED is lit, replace the
adapters and devices one at a time until
you isolate the problem.
3. Power supply.
4. Power cage assembly, if installed.
5. System board.
On On Power is working properly. N/A
1
Adapter jumper (J42)
2
Boot block recovery jumper (J28)
3
System board switch block (SW1)
1 2 3 4 5 6 7 8
OFF
1
2
3
1
2
3
1
2
3
1
2
3
1-2
Disabled
2-3
Enabled
Update
1
2
3
Normal
1-2 2-3
Figure 14. System-board switches and jumpers
Appendix D. Symptom-to-part index
147